Aluminum Trailers

  • Thread starter Thread starter JZ
  • Start date Start date
I just bought a new aluminum trailer with the stainless fasteners upgrade. It has urethane bushings between dissimilar metals. Other than the contact points where dissimilar metals might touch, aluminum used in boat trailers isn't likely to corrode unless neglected and used heavily in salt water.

Loadrite, Road King, Venture, Wesco are four brands common in NC. Don't know about West Coast. Mine is the Venture.
 
We have a loadmaster aluminum trailer. 75 miles into the trip back from the purchase had a bearing overheat, a warped bearing - just enough to make it overheat. Had all the bearings replaced, not willing to take a chance on others being bad. The warranty settlement was under $25, they would not pay for any labor nor for the other bearings as they were found to be acceptable. Terrible customer service!!!!! Other than that the trialer has been ok. I would not recomend the company due to attitude.
 
JZ,
I have experience with both steel/painted and Aluminum trailers. Only fresh water use with both trailers. I used an Eagle steel trailer, 3-axle on my 30' Sportcraft boat for ~10 years and quite accidentally found that the cross members were rusting internally. Even had to drain gallons of rusty fresh water from the square channels. Luckily the trailer was stolen and I had to replace it for our 32' Chris Craft boat.

Our second trailer is a E-Z Load aluminum, 3 axle, rated for ~12,000. We have only used it for moving the boat to and from winter storage and have no problems with the trailer. It has brakes on two of the axles and the boat is "sling" loaded and unloaded. It also has a hose connection for a brake rinse system that allows flushing the drum brakes internally - that we have never used.

I would go with an open channel aluminum trailer - assuming you rinse it off with fresh water when ever possible.

Port Clinton, OH
 
JZ Check out Pacific trailers in California, otherwise buy a MYCO out of Bradenton FL. Full welded aluminum with blueprinted bungs.
 
I have two aluminum trailers used regularly in salt water--no corrosion. Remember that there are a number of very high end aluminum boats which are in the water all of the time, and do not have corrosion problems. It depends on the alloy.

I wash the trailers down regularly--and after each dunk, with a hand sprayer--mostly to be sure that the SS brakes (get Kodiac--not Tie down) disc brakes. The I beam trailers are lighter, and less subject to corrosion than the galvanized trailers I have owned in the past 50 years.
 
I have a Boatmaster trailer, custom made in Ft Myers and highly highly recommend them. Talk to Joe, the son of the guy that started the company. They make trailers for the military which has pretty tough standards. A small but important item, they make the trailer so the bunks can go directly on top of the I-Beam which is the way I-Beams are meant to be used for structural support. Every other trailer I looked at put the bunks on a cross beam which twists the I-beam and is not correct...it may work but it ain't right! I had a few warranty problems which they handled and shipped to me in Colorado without problem. Everything corrodes in saltwater but aluminum with ss or bronze disc brakes and torsion axles is the only way to go. I've hauled my 12,000 boat on their trailer from Florida to Colorado, 3 times from CO to Washington State, numerous trips to Lake Powell, and once to the Sea of Cortez and never had a problem with it. I think I must be a rare person that has had their boat on 3 corners of the USA...and I don't plan to go to Maine..no offense intended!!!
 
quote:

Originally posted by GaryP

...and once to the Sea of Cortez and never had a problem with it.






Where on the SOC? I have my boat down in San Carlos, Sonora now.
 
Back
Top