Cavitation Plate

Thompson16

Member
Joined
Mar 26, 2001
RO Number
3945
Messages
13
I have a 2-3 inch crack in my cavitation plate - had a mechanic check it and he said as long as it doesn't get any worse that it shouldn't be a problem.

If it does get worse - can this lead to flooding of engine compartment etc?

Boat is a 1998 Wellcraft Eclipse, 5.7L Mercruiser I/O with an Alpha One outdrive
 
I've been told that it's difficult to weld aluminum...

Crack is from the edge of the plate to about 1" shy of the outdrive
 
I fixed one about 15 years ago with JB Weld and it is still holding strong today. Just make sure it is clean and ruffed up.
 
Places that repair props usually can repair the aluminum outdrive.

Aluminum is not hard to weld if you have TIG or MIG or heli-arc.

Gas tungsten arc welding (GTAW), also known as tungsten inert gas (TIG) welding, is an arc welding process that uses a nonconsumable tungsten electrode to produce the weld. The weld area is protected from atmospheric contamination by a shielding gas (usually an inert gas such as argon), and a filler metal is normally used, though some welds, known as autogenous welds, do not require it. A constant-current welding power supply produces energy which is conducted across the arc through a column of highly ionized gas and metal vapors known as a plasma.

GTAW is most commonly used to weld thin sections of stainless steel and light metals such as aluminum, magnesium, and copper alloys. The process grants the operator greater control over the weld than competing procedures such as shielded metal arc welding and gas metal arc welding, allowing for stronger, higher quality welds. However, GTAW is comparatively more complex and difficult to master, and furthermore, it is significantly slower than most other welding techniques. A related process, plasma arc welding, uses a slightly different welding torch to create a more focused welding arc and as a result is often automated.[1
 
Skegs and even gear cases are regularly welded. Fins, like the Permatrim are regularly bolted to cavitation plates. I have also used JB weld to repair Aluminum--that is a good place to start. The gears of the lower unit should have seals around the shaft, which will prevent water from entering the gear case from the leg. But just a crack in the cavitation plate should not cause a leak.
 
Back
Top