DIY Hardtop

G-

on a hardtop, water tends to roll to the lowest point on a drip edge- and then falls almost straight down. Look where his helm seat is- right under the drip edge. I'm sure it's like being under a cold faucet in the right conditions.
 
quote:

Originally posted by In the know

quote:

Originally posted by Capt. Bill1

You can tell you've never done this kind of work. Because $750.00 does not sound "ridicuously stupid" in the least to me. But there is a touch of irony in that statement. ;-)

There are a couple of good books out there on fiberglass work. I'd pick up one of those and give it a read before you start.






I meant in the sense that $750 is too low.








Ah, sorry, missed the sarcasm. If they do good work why not go for it? Perhaps they just need some work.
 
I showed a fabricator pictures of Saint Max. I wanted to raise the arch and HT to keep from whacking my head at the helm. He quoted me $800 for everything not including canvas extensions. That would be raising the arch, extending the 4 support poles and finish work. That said, $750 to a grand seems plausible.

My $0.02
 
That is a great boat,I know it from the south river in scituate mass.Last owner took good care of it and had lots of fun ,pursuit with inboards handles well.
 
Extending the current top in the middle seems like a good idea, but a little canvas and a drop curtain might be better. Nice to keep the hardtops out of the way of fishing.
 
An alternative to fiberglass work would be to use some 1/4" Lexan heated and shaped to the aft profile of the existing top. Then attach say 18 inches to the aft edge of the top. With some window tinting applied (or use tinted Lexan) you would have an extended top with some additional shade protection. Less labor and less moldwork than fiberglass and very likely less cost in materials.

Your rocket launchers would have to be modified because the Lexan wouldn't support the weight or the stress of rods bouncing while underway.

I have shaped Lexan and acrylic with a heatgun and a torch. I understand that Starboard can be bent using a similar technique but I haven't done it, yet.
 
Back
Top