sounding a hull

Brian

Member
Member
Joined
Mar 2, 2000
RO Number
64
Messages
334
How does one go about sounding a hull. What kind of hammer is used and what are you listening for. How far apart do you do it? Anyone ever do this while looking at a boat or did you leave it to a surveyor. I know people say use a moisture meter put from what I have read the results can be all over the scale.
 
It is called a Phenolic Hammer. Most competant surveyors have and use them to check hulls and decks for any signs of delamination.You can also use the plastic end of a very parge screw driver but the sounds are not as discernable as using the hammer. You listen for a good "solid" sound when hitting the area. Any higher pitched or hollow sounding response would indicate the possibility of delamination and should be tested further.

quote:

Originally posted by Brian




 
Believe me, when you hit a bad spot with the hammer, you know it immediately.
 
ding ding ding ding clack clack clack clack ding ding ding ding, clack clack clack clack THUMP
 
It's not the thump, it's the THUD you don't want to hear.
 
Actually you don't want to hear "Oh SH!rb2@gr5t". That usually indicates a failure in the fiberglass the size of the hammer head.

MJK
 
When I was doing some surveying it was suggested that one should use something small that had a comfortable handle and a relatively soft strike area. Bad form to ever expose a faulty bottom. I settled on using a medical gizmo used to test leg/knee reflexes.
 
I use a brass hammer as I found the report to be truer than plastic (I've never marked a boat) Basically the previous posts are correct but oversimplified. Every boat has a different layup schedule and some are cored with balsa, various closed cell foams or coremat type materials. Distinguishing all of these different sounds is not quite as simple as interpreting thud, thump or whack!
I have sounded over two thousand boats and seen hundreds of them opened up. Until you have seen the skin opened of a hull you have sounded you can never be sure of what you are hearing. Its an educated guess in all but the most simple cases such as core separated decks or very wet decks which are easy to determine even for the inexperienced.
 
Back in the early days of fiberglass and composite materials, they used a very sophisticated tool to sound a laminate and it still works very good today and only costs $1.00. Its a $1.00 coin. Tapping with a large coin produces a very distinct difference in sound from solid laminate and a delamination.
 
The change in sound tells you simply that what you just tapped is different than what came before it. You still need a person who can form an opinion on whether it should have.

Do we really think that there are people here that think that a hammer does the job all by its self?
 
All well laminated fiberglass will emit a sharp distinct sound when tapped. If its delaminated, it will sound dull and hollow-like. Yes, if you are not confident in determining the difference in sounds, then it may be advisable to hire an expert. Tapping a laminate is just to provide a cursory investigation as to whether there may be significant delaminations. Other methods such as ultra sound are available if an area is suspect and you want to incur additional cost.
 
I was thinking what boatpoker said about different coring material. Foam coring has to sound different than balsa and so on. I guess it boils down to experience.
 
Back
Top