Still not sleeping

Just a thought.
If the Admiral isn't happy.......
Drastic measures might be in order.
How about trying some duct tape along the chine at night? If it helps it would be worth the few minutes that it would take.
 
Allow me to chine in here...
The "slapping" that you hear could be water getting trapped under the "chines" each time the boat rocks/lifts. Thus the suggestion for a displacement (round bottom) type boat. Here's some def's.

Here are a few more terms you're likely to encounter in bottom design:
Round bottom— These are used mostly on vessels intended for displacement speeds. Round hulls provide a gentle ride with little fuel expenditure, but tend to roll from side to side in certain sea conditions.

Low deadrise bottom— Sometimes called shallow-V bottoms, these running surfaces have a deadrise angle of 20 to 25 degrees amidships which reduces to 5 degrees or less at the transom. (Deadrise is the angle measure of the "V" in the bottom. It is generally greater at the bow, or "entry" of the boat, and shallower at the transom, or stern of the boat.) This provides a smoother ride, but it still retains the quick ability to plane of a flat-bottomed boat.

Deep-V bottom— This type of hull has a deadrise of 25 degrees amidships with reduces only slightly to 20 degrees at the transom. This shape allows high-speed operation in rough water.
With few exceptions, planing hulls have chines and strakes.

Chines are the angles on the hull where the vertical topsides meet the bottom. Older designs often had rounded or "soft" chines. Today's hulls almost universally have a sharp corner or a "hard" chine. Round-chine boats tend to roll a bit more, so they're not favorites with anglers who prefer the stiffer characteristics of a hard-chine boat. (A boat that resists rolling is said to be "stiff.")

Strakes are those little "ridges" you see below the chines. Their primary job is to provide lift, which is important in the planing process and overall running efficiency.
 
The waves slapping the hull merely add ambiance sound to O'Brian's Capt. Aubery and Dr. Maturin audio tapes at night.
 
Holy cow,

I guess there are no third shifters here.

Run a fan, any white noise will mask the other sounds and put you to sleep.

Jim

2004 360 DA
 
Is masking noise with more noise a good solution?

Dave

Faster now but still steady
 
RO, how many times have you actually slept on board and had this problem.?
I think it is really something you have to get used to. It took me a few months of sleeping out every weekend before I got used to it. Now I actually like the sound as it reminds me that I'm not at home. (We generally call it lap-lap)
I must admit where we anchor the wind usually dies down at night and there is no lap-lap at all until the wind starts up again mid-morning.
But even on the windiest nights I actually love the sound.
 
Back
Top