A/C Duct

rnbenton

Active member
Member
Joined
Apr 4, 2009
RO Number
31163
Messages
2,834
I am installing an A/C in my 28' Carver Voyager. It will be located under the forward dinette bench right beside the water heater. all is well and everything fits very well with good access to electric, water source and drain.

My question involves duct. Because of the location of the unit and the location of the registers my longest duct will only be about 3'. A local "expert" has advised that, because of the short distances involved I should simply use clothes dryer vent hose for my duct work.

Opinions? Can this possibly be a workable setup? Will air flow be adequate? What about the possibility of condensation?

Thanks
 
The shorter the duct, the more air flow due to less frictional losses.
It should blow good as long as the duct is the correct diameter and there
are no kinks in it.
If you have no insulation, I can promise you that you will have condensation,
unless the air around the duct is the same temperature as the air in the duct.
The air in the duct should be between 55 and 60 degrees.
 
I'm no expert by any means, but my first thought is condesation dripping off the vent hose.
 
I agree. That's what I thought but I thought I'd ask anyway just for informations sake.

Thanks all of you.

quote:

Originally posted by sabrejocky

You just need to go to HD and get some flexable insulated a/c duct.

Cor




 
What does the A/C unit say, Mine says a 6 in. duct and a 4 in. as min. You have to flow enough air otherwise it will freeze up.
 
The outlet flange that came with it is 4".

quote:

Originally posted by JimPend

What does the A/C unit say, Mine says a 6 in. duct and a 4 in. as min. You have to flow enough air otherwise it will freeze up.




 
I have a two foot run on factory installed AC and they used dryer vent hose. No problems in three years.
 
TopandKandi, hard to believe it doesn't sweat like crazy, especially on extra hot & humid days.
 
It must be insulated or you will cause lots of water damage from the condensation.
 
It won't cause damage if it drips directly into the bilge, but you do not want water inside the boat.
It will cause the humidity to go up and you will start getting mildew problems.
If it drains on or near any wood, you will have problems selling the boat in the future.
Get an insulated piece of duct. Go to an a/c shop and see if they will sell you a piece of scrap that
they have left over from any big jobs. They might even give it to you. It is cheap.
 
Bottom line; buy insulated duct. Cheap, no head aches, no problems, end of story !!!!!!!!! What's there to think about ???
 
Insulated duct is easy to come by or make, take you dryer flex and wrap 2" of fiberglass
around it and cover with plastic sheeting. easy! Now the hard part, measure the size of
the supply air opening on the unit, what ever duct you use the sq inches needs to be the
same or slightly more then the supply. Do not restrict the return air or you get even more
problems. sq inches for round duct are easy Pie X R squared LOL ( no pie symbol on the
board)

.,
 
With no insulation on the duct, the longer it will take to cool the boat down.
The heat outside the duct will warm up the cold on the inside of the duct.
Normally, where the ducts are located, never get too cold. So you will be
wasting electricity or fuel generating electricity to inefficiently cool the
boat down over a longer time.
Insulation is a good thing or it would have gone out with the Edsel and Pop
Rocks.
 
Back
Top