If this bothers you, leave the breaker alone, and add a fuse to the light fixture. I've "cooked off" my share of electronics, and imho, the control electronics for a LED will self-immolate itself long before there is a fire. ( ie: 1/8 or 1/4 watt resistor or current limiter ) And in many cases, there -is- a small, PC board fusible link inside the control electronics. Adding an inline fuse will do little harm. But it is pointless to have a 5A circuit reduced to let's say 0.5A simply because the load is 0.5A. Fuse the circuit correctly. And, if required, separately fuse the load device. Further, I would very likely have far more than one LED light on a circuit breaker. It is much more likely that I would have several devices on that circuit. ie: breakers for circuits that have all Nav Lights or all Cabin lights. You are unlikely to have circuit breakers for each individual LED fixture.
As to the fire risk: keep in mind that a LED fixture will more than likely be rated for less than 10 watts ( some recent LEDS could be slightly higher ). It is very difficult to burn -anything- at less than 10 watts. And if there is greater current, the electronics will fail, ( fried ) open circuit. Every LED I have seem fail has failed open-circuit... ( fried )