Cradle Lift Help!

Rugger8

Member
exMember
Joined
Dec 4, 2006
RO Number
24444
Messages
231
I am looking at building a dock and a boat lift for my Regal 3560 with a dry weight of 15,200 lbs. and a fully loaded weight of aroun 18,000 lbs. I live in a tidal area on the Hudson River. I was wondering if anyone had any experience with Qualityboatlifts or Davitmaster boat lifts. Both of these companies are in Florida. Also, if there are specific things I should be looking for in a boat lift.

Thanks,

Jeff
 
Shouldn't you be looking for a permit from the Army Corps of Engineers if you are sinking anything (support poles) into the river bottom? Good luck.......G
 
yes, I do need approval from the US corps of engineers. But in this case I am trying to determine if any specific lifts are better or worse than others and if so, how much better to determine if it is worth paying a premium for one versus the other. Both are mounted on piers that are pile driven into the river bed.

Jeff
 
Lots of lifts in this area but i have not heard any complaints about any brand. If your lift will touch bottom those constant tension devices are a good idea.
 
Rugger8
Stick with the overhead lifts. Cables do not overlap and do not bird nest.
What ever lift you choose get the dimension so you can order a stock lift.
Keep poles high so the lift will be at least 6' above pier. Head Banger.
Also these lifts can lift the boat higher for flooding conditions.
I had one custom made (Galvanized) lift here in Maryland 20,000lbs $7,500.00 installed.
Quality lift will run you about $11,000.00 not installed.

The boat can be raised to just about a foot below the beam.
 
Steamer 123,

That looks great. Do you have the info from the place that made it for you. My boat needs are for a 20,000 lb. lift as well, so maybe I can contact the shop that made it for you or use the plans with someone else here.

Jeff
 
Western Shore Custom Marine Products
Boat Lifts
510 J Orems Rd.
Baltimore, MD 21221
USA
Phone: 410-687-7457

Quality builds good lifts they are all aluminum except the main support shaft is galvanized pipe that's why I went with the cheaper galvanized lift.
Go to a boat show and the marine construction guys can point you in the right direction to get one custom made.
My lift has limit switches to stop/start at present limits. Also has an override to lift boat to maximum height in case of flood tides. This is a nice option you don't have hang around for the boat to lift and these lifts are in no means speed demons.
 
I have a 16K boatlift by Quality Boat lifts - before it I had a 10K.

Nice little remote to lower into the water and lift out of (without having to get off the boat to do so) - this may seems minor, but, when I borrowed my neighbors lift while ours was being installed I had to pull the boat to the pier, lower the lift, pull the boat onto the cradle, lift the boat up. (Tidal difference from leaving to returning back)

With the convenient remote, I have some electrical tape around one of the guide poles that indicates that the cradle is at the proper heigtht for the boat to be able to get on. I simply pull near the dock, raise or lower the cradle to a poin where the tape shows right at the water line, then drive the boat right onto the cradle.

The QBL have guides in the cable winding area that keep the cables from "over lapping".

Any questions - just ask!
 
Back
Top