Final Floor Repair Question

thompsdw

Member
Joined
Nov 29, 2003
RO Number
12507
Messages
57
Thanks to all that helped on my floor repair. I listened and replaced the floor section. Kinda a PITA, but it is done now. Here are some pictures:

http://i148.photobucket.com/albums/s18/thompsdw/IMG_2167.jpg

I do have one more question. I do have some areas of the repair that need to be leveled and I am having a hard time doing that with epoxy. I tried silica as an additive, but it doesn't seem very soluable. Can I use bondo over the top of the epoxy to level?
 
Ok, I should have googled more. It doesn't sound like all bondo products are waterproof. I don't have a good marine supply store in the town I live in. I guess I will have to look around. Any advice for small town source would be appreciated.
 
You can use rot doc's epoxy filler, it's expensive but works very well.
A little on the thick side though esp since the weather has been cold.
 
Looks fine like it is. I wouldn't bother trying to fair it.

You can use a combination of micro ballons with the silica. It's just glass bubbles that make a lighter filler and sands easily and is a good fairing coumpound. You should put a seal coat after sanding.

Depending on who's epoxy you used, you may have to do some amine removal from the surface of the cured epoxy. I've been using Tap plastics marine epoxy for years because it has very little amine. Their products are cheaper than West
 
I am recarpeting and the corner is low enough that I believe you will feel it underfoot. I guess I will try the silica again. The epoxy was so thick, that it was next near to impossible to get to dissolve evenly.
 
Don't use straight fumed silica. It's way too hard to sand easily. Heck, you can use silica to thicken and mix fine sawdust to make a putty consistency. It takes a lot of mixing to mix silica because it's sooo fine. I buy it by the 25 lb bag.
 
Back
Top