Furuno NavNet VX2

dreck

Member
exMember
Joined
Mar 4, 2009
RO Number
31099
Messages
10
hey all. new to the board. been bouncing around on some of the discussions and i'm very impressed.

hoping you can give me some insight into an issue that i can't seem to get to the bottom of.

i have furuno navnet vx2 system (of course installed less than 12 months before the 3D!!). anyway, i have a recent (june 2008) east coast wide-area c-map sd card.

my problem is that unless i zoom way in, all the detail is grayed out. is this a navnet problem, a c-map issue? it drives me crazy.

any help would be appreciated. thanks
 
I have Navionics Gold on my VX2 system, but a quick look through C_MAP part of the manual, these questons arise:

Are you using a Furuno VX2 specific C-MAP NT MAX chip ?
Is Chart Level on Locked instead of Unlocked?
Is Chart Mixing on or off?
Is Chart Display Mode set to Full?

Furuno's help/support site is very useful, as are their call in techs. You might try them in the morning.

George
 
thanks for the quick response. unfortunately i don't know the answer to any of those questions bc i am not on the boat currently.

i am pretty sure the settings are correct, because i went thru the c-map part of the manual when i was in front of the unit.

as to whether its a vx2 specific chip, i have no idea. i bought it from west marine and i assumed (wrongly?) that the sd c-map chip i bought was compatible with navnet2. i didn't think that there would be differences in the chips themselves.

is that normal that they would make specific chips for specific plotters?

also, is there anything inherently better about the navionics chip that would suggest that i switch? where would be the best place to buy so i make sure i get a chip set-up for the vx2?

thanks
 
You plotter is set up for C-MAP, so no switching. BoatFix, the sponsor of this forum, is a great place to buy nav chips. Come to think of it, I don't think C_MAP SD chips work on any thing but Furunos, but let me emphasize that is a semi-educated guess. Someone far more expert than I will chime in on that issue and your problem. Or Call C_MAP 800-424-2627or Furuno rb2@gr5t410-479-4420

George
 
Give our Customer Care Department a call, we can get you set up, as well as send you a free guide specifically to fine tune your vx2 settings.

Our data can programmed onto several different chart card types, used by various different chartplotters. SD-cards are used by Furuno 7000 and vx2's as well as some newer model Navman, Northstar and Simrad units.
 
Back
Top