Line Wrapped Around Prop

cbwallace

Member
Joined
Apr 29, 2004
RO Number
13491
Messages
5
During a storm this past summer we had a line for a tube go over and get wrapped around one of the props. After several dives under the boat I was able to get it all cut off with no futher issues. However, when the boat was pulled for the winter I noticed some fibers from the line still wedged between the shaft and the aft end of the strut. Will this cause damage to either the strut or shaft? The fibers are very short and are not wrapped around the shaft, but I was surprised to still see them after a few months.
 
cut them out, you don't want to block any water flow through the strut
 
PROBABLY not... They MIGHT have caused damage to the rubber cutless bearing (they're pretty tough). Is there any play in the shaft? If not then I wouldn't worry about it.
 
What good can come from leaving them there? And what bad from leaving it? I say none and none.
 
How easily does the shaft turn in the cutlass by hand? It you get it started and it there is still a lot of friction, you may have a problem. See if you can pull out the fibers with needlenose.
 
Thanks to all for the feedback. There does not appear to be any play in the shaft and it does turn as easy as the other shaft so will try to pull out remaining fibers and let it go. Getting caught in a storm with 70 mph winds on the upper Mississippi does not provide for a good afternoon. Luckily the line was the only issue we had.
 
Back
Top